Intex Seahawk 4 Upgrades Wooden Floor 

I have the seahawk 2,and have added a wooden floor.Without the floor the power of the engine bends the tubes in the middle.I have the floor in two pieces,one longer than the other so they overlap by about 5cm.This prevents the joint from bending.Also, two pieces fit in my car and are easier transported.Most inflatables lose pressure when the tubes are introduced into cold water,so I take a hand pump with me to top up.

Nice work !

No need to talk when your actions are so crystal clear, however, it was too quick at the end there. Couldn’t tell with the orange tool was .You are a true craftsman. I bought the sea hawk 4 Two people full gear very comfortable. Trolley motor minimum 40 pounds of thrust amus I have the Intex motor from 2011 and it’s wonderful. Happy sailing mate

Hello dear friend nice sharing 👍👌❤️

Top!!!!! 👏👏👏👏

bravo !!!!!!!!!!!!

What is the size of the floor board? Width and length. Thanks for your reply.

👍👍👍👍

Thats really dope , do u still blow the floor chamber ? Or not ? 🙄 and could i have the mesurment please 😁

Shold be bigger for snuggfer fit and go under the tubed (will be more stable when tubes are inflated). Also using zipties are bad idea, because they are kinda sharp on egdes and may rub the tubes material if too way outside on insulation foam. Using zipties is unnecessary is this applicatuon.

Did you end up attaching the 2 halfs together or did you just leave yours separate?

Has this boat held up?

Nice Video, can i have measurement?

To much work for such a simple job😊

What mm is the wooden material and are you able to fish standing with the floor

Nice video mate, why do you think its nessasary to have the wooden floor cut out for the valve?

How thick & What type is the plywood?

Are you able to stand on the boat?

Why not use a sewing pattern wheel to trace out the pattern?

Do you make & sell?

Easier way to trace is use a dress makers pattern tracer wheel

Sir can i have measurement??

It's good to see Woodglut have new instructions to save my money and energy to build it.

Good work but i hate no word videos. Lol

Hello.i want to say this,be cerfull when you go out to the water.Everybody must know,this thing is dangerous.I build a wooden floor myself for seahwak 4.I went with afreind to alake and while we were far away from shore,at adeep of 20 meters,we fell to the water...this boat with awooden floor is dengerous.please think twice.Nobody talks about that.Sorry for saying this,i was very enthusiastic myself when i built it.

I bought a seahawk 3 and the bottom is separating from the sides. It's only 4 months old and Intex will not replace it. ***Do not Buy***

started off good, but you ruined it in the middle by fastforwarding way too fast. I can't see what you're doing. Why did you break out the cardboard again and do all those measurements etc. when you already had the stencil on the plywood??? it gets really confusing around there. Sad because It was almost helpful. There are so many poeple doing this modification, but NOBODY really does a good job of showing you how to do it. This wasn't really helpful at all. Just you showing off I guess.