J&L Oil Separator Co. 2024 Ford Mustang GT 5.0L Oil Separator Install 3091P 

You maybe able to sneak it out of there, but it'll probably be safer to remove the bar to avoid scratching the cover up.

@@jloilseparatorco.1853 agreed, I'll loosen the strut bar and put a towel over the cover.

It’s a little more tricky but just lift the cover off of the mounts and move it (back) out of the way the best that you can. No need to removed the strut bar

It is, and this kit interrupts the line on the passenger side. It just mounts over on the driver side 👍

@@jloilseparatorco.1853 Thanks for the response. Do you sell a replacement hose to go to the passenger side for the 24 S650 kit?

@@BlaznBlu504 Not typically, really depends on the situation. Reach out to us at info@jlosc.com with what you need and we'll see what we can do for you.

@@jloilseparatorco.1853 thanks. Sending an email now.

Yes it will. No issues.

@@jloilseparatorco.1853 It was slightly more difficult because I couldnt' get the engine cover out from under the strut bar

It could be the o-rings inside the fitting. We recommend putting a bit of light oil or grease on the o-rings before install.

Not at the moment. In our experience the clean side sees little to no collection in comparison to the dirty side. We'll come out with one eventually, but the dirty side was our first priority.

​@@jloilseparatorco.1853is it possible to put one on from gen 3 models? Will they fit? Thanks in advance

@@coyotegoot on the clean side? Can't say for sure without having one in the shop and trying it out, but not likely. The PCV side definitely won't fit from the earlier years.

This kit covers the dirty side, which is going to handle the vast majority of your blow-by. We wanted to focus on this side first since we were doing this R&D away from our shop in the middle of Mustang Week. Eventually we will do a clean side kit for these.

I hope soon for when I get my supercharger