Thanks. Yes, it was well used. But it was a really fun project. Since I bought it for just over scrap metal price, the initial investment wasn't too bad. I got lucky to find used tires for cheap ($600 for the pair, delivered) because otherwise those tires are about $1500 a piece!
Great job, what tractors do you use on your farm? Enjoy all your videos. You could line all your tractors up and give us a description and history. Would be really great. Thanks
That was cool. I have a question, why did you go with the oversized pistons, instead of using standard pistons and having the block sleeved? I am just curious, as I have a 41 A and might rebuilt the engine at some point.
I went with oversized because they were available. In my mind, if they are available, it's easier to just bore out and buy oversized pistons. The only time we have sleeved and then returned to standard was on our H and our LA, because we couldn't get oversized pistons.
@@jonelsonster that was my thought. The standard parts for these old girls are getting harder and harder to find. It makes sense to go with what is available. Thank you for your reply. I have another question. How difficult is it to change the clutch fork and bearing on an A?
Depending on how "stuck" it is, you may be able to pour penetrating oil into the cylinders and work the pistons free at the flywheel. If that fails, you'll probably need to pull the head off, disconnect the rods from the crankshaft and pound the pistons out with a hammer. Don't hit the pistons directly. Use a wood block or a section of 2x4 if the pistons are towards the bottom of their stroke. We've done this a couple of times. Then bore the cylinders and buy oversized pistons. Good luck 🤞🏻
I've tried a gallon of PB Blaster in the cylinders with no luck but I haven't tried pounding the pistons back. Will try that this coming spring. Wasn't sure if pounding on the pistons would cause other damage. Thank you
I just acquired an single front end for my 48 A and I noticed that only on one side just above spindle there is a 3/8 bolt that holds shield on the yoke. Why they didn’t do the other side I don’t know.
I always use Van Sickle paint from my local ranch store. I think it's very good quality, I like the color, and it's affordable. And I buy the catalyst hardener and mix that in too. You have a few hours of pot life, but it sprays on easy and hardens with a nice glossy appearance. The hardener makes it resistant to gas or other solvents, so it stays looking nice. And if you ever have to touch it up, they sell spray cans of the same color and it is a very good match.
the engine and the cylinder head can be welded up as long its not.leaking in the engine cylinders most likely water 💦 😮 was left 👈 😮 in the tractor 🚜 😮 and it froze U should use water no way antifreeze year round it cools alot better after the tractor 🚜 😊 is back 2 gether and running U 😊 have 2 get all of the air out of the cooling system it may take a while 2 do so it the tractor 🚜 😊 run the engine has 2 warm up 2 do and it may take a few times the tractor runs good it still sounds like its on the old 6 volt system it needs 2 be changed over 2/ 12 volt alit more cranking amps 2 turn the engine over alot faster all of the old 6 volt batterys are just about gone they are a thing of the past now cars and trucks changed over 2/12 volt in the mid 195OS 😊😊 OMG 6 2O 2O24
Luckily I was able to buy an entire parts tractor with an un-cranked block and head for only $120... So I went that route rather than trying to repair the cracks.
