In this video I bore a worn and corrosion damaged Early John Deere A block .045” oversized to give it back a decent ring seal and a new lease on life. Follow along for the 5.5”+ cylinder boring on the HBM. Thanks for watching!
Glad I got to see my block being bored! This orchard tractor will be a trailer queen but the rest of mine aren't, you will be getting my 730 gas this winter it's getting tired!
I'm from further north so I have to watch at 1.5 speed to understand you. Great work! I've been following you for over a year. I like that you show your measured results.
Thank you for a great video on boring those cylinders. I’m also interested in how you honed those too, I can only imagine it what a grueling process it must have been.
👍👍...glad you're helping put some new life into that old piece of iron... thanks for sharing this with us all... have a good weekend feller..see ya next time 👍👊🍺🍻
@@bcbloc02 Yes I watched that hole fork lift build videos. I have always been interested in the 2 Cylinder JD engine. I was lucky enough to drive a John Deere 80 diesel in my youth ( mid 60’s) pulling a 5 bottom trip hitch plow. But I’ve never seen the inside of that engine, but I am still curious about them. I suppose the only rebuilds are collectors projects. And I’ll take this time to say thanks for all the videos you’ve put on RU-vid.
Very nice job Brian. I always like watching you use the Big HBM.👍 Awesome machine. First blocks I honed were with a Sunnen AN111 and a Low speed 1/2 Drill and still did good work. Thanks for sharing. 👍 👍 Have a good Memorial day weekend.
