M4 35 Unboxing & Assembly
This is the aluminum packaging case of M435. Open it.
Here are M4 35, fixed columns for the landing gear, landing gear, load plate, four propellers, a transmitter, and a Screwdriver Socket Wrench.
Then we’ll show the assembly of M435.
At first, overturn the aircraft.
There are 4 corners in total, with 2 columns in each corner. Rotate the 8 columns to fix them.
Here is the load plate, with a servo and hook on it. There is an arrow. The arrow points the aircraft head.
The servo can be connected to the cable here. Connect them based on the colors of the wires. Then point the plate forward and install it. Tighten the plate with the screws.
Here is the landing gear.
The foam side faces the ground. Tighten the landing gear with 8 screws.
This is what it looks like after the landing gear is assembled.
At last, install the propellers.
As the image shown, put the head forward. Propellers on Motor 2 and 3 rotate counter clockwise while Propellers on Motor 4 and 1 rotate clockwise.
(Make sure the installation of each propeller is correct. Otherwise the aircraft may fail to take off. )
The side of the Propeller with letters faces upward.
The high side of the propeller points in the direction of rotation.
So this propeller rotates clockwise.
This propeller rotates counter clockwise.
This one clockwise and this one counter clockwise.
Place propellers in the corresponding corner.
Here is the Screwdriver Socket Wrench. Remove the cap nut, insert the propeller, put back the nut and fix it. The same way for other propellers.
You can hold the motor below when you fix the propeller with the wrench.
The assembly is done.
For more details of M435:
www.radiolink.com/m435
If any question about A560, please feel free to contact us via email: after_service@radiolink.com.cn
#drone #heavy lift drone #radiolink
8 мар 2024
