MKS VESC 75100 Firmware Upgrade and Calibration 

I'm trying to configure the vesc tool so that I can use a potentiometer on the adc2 input, so that it works as a pedal-assisted power regulator on my bike, I use an accelerator on adc1 and a common cadence sensor, but it is dangerous to use the assisted pedal if you are using a profile with a lot of power, my intention is not to need to use a smartphone to change the profiles but just a way to change the assistance...

Can you share the Github source for te firmware? I want to enable a second throttle for brake and reverse without the need for a button.

Thank you

I did everything as in the video instructions. Everything was successful. But on the next connection, the computer does not see the controller. Installed drivers. Tried on Windows 7 and 10. Nothing helped. Please help.

Hi bro do u have the BOM of this? Because i see on github just schematic V1. And what is defrent V1 and V2??

Setup an MY1020 on a razor and it refuses to have a smooth start. Motor clunks and stutters at start; also runs slower than a stock vevor motor controller. Any thoughts on fixing this?

My vesc tool does not detect the 75300 but show the 75100 When run detect motor, vesc automately disconnect. Can u help me