Scroll down for configuration Links (MUST READ NOTES FOR CF INSTRUCTIONS!)
Note - I'm using a rev5 Naze
github.com/multiwii/basefligh...
Make sure that satellite has been connected correctly
Make sure you have the latest cleanflight flashed to your FC
Connect Naze32 Rev5 to USB
Open cleanflight and connect to Naze32 (baseflight app in Chrome)
In the ports tab, choose UART2 : RX = Serial RX
From Configuration tab make sure that you have selected "Enable Serial-based receiver" and Serial receiver is correct (e.g. SPEKTRM2048 for DSMX)
From CLI tab type: "set spektrum_sat_bind = 9" for DSMX or "set spektrum_sat_bind = 5" from DSM2
type "save" and after Naze32 reboot remove USB cable (=Power off the Naze32)
Wait a sec and reconnect the USB cable. After cold start satellite led should start blinking and transmitter should be turned on while pressing the bind button.
After binding satellite led should be solid. Connect cleanflight and use receiver tab to test that satellite is working correctly.
Final step is to go to CLI tab and type "set spektrum_sat_bind = 0" and then type "save". This must be done so that satellite doesn't go back to binding mode when Naze32 is repowered again.
my flight controller
www.abusemark.com/downloads/na...
This process works for clean and base flight
github.com/multiwii/basefligh...
More info about binding
www.helifreak.com/showthread.p...
More dox - PPM Pulse decoded
wiki.openpilot.org/display/WI...
25 июл 2015