Nissan / Infiniti Throttle Relearns

Подписаться 1,9 тыс.

Просмотров 54 тыс.

50% 1

Watch this video to perform an Idle Air Learning Procedure without a scantool, after replacing the electronic throttle body.
Vehicle used: 2003 Infiniti g35
The part depicted in this video may fit other vehicle applications, and installations may vary from application to application. Certain vehicles may require different, more or fewer steps. Follow all safety precautions and procedures recommended by the vehicle manufacturer prior to servicing the vehicle. Pay special attention to all warnings and safety systems involved in this repair. Review the disclaimer at the close of this video.
To learn more, visit: www.NAPAEchlin.com

Опубликовано:

6 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 23

@stevianz3398 3 месяца назад

Thank you for taking the time and sharing your knowledge with us. I finally got around to sorting a high idle on my SUV. 09 FX50 with push start button. Followed your instructions along with your video and now it's running as it should.

@02room 13 дней назад

i have an fx35 with push button start as well. When in the video he says "turn the key on for 2 secs"... then "turn the key off for 2 secs"... do you simply push the start button once (for "turn the key on for 2 secs").... wait for 2 secs ... then simply push the start button once again (for "turn the key off for 2 secs")? I only ask because I noticed the push start turns on "more" things, like the radio, heat, etc., when you press it a second time, and not sure how many times i should be pressing. Thank you.

@stevianz3398 13 дней назад

@@02room Yes you need to press it 2 times so it is "ignition in" per say. If you press 1 time it will be on accessory (radio/media). You need to press 2 times so all lights come on.

@michaelbotello8834 12 дней назад

What if there is no check engine light on after i cleaned the body throttle?

@TechScottBrown Год назад

Excellent tutorial, thanks

@spankgo1 8 месяцев назад

Is this relearn process necessary for 2010s and newer after cleaning throttle body?

@Mistr_Vq 11 месяцев назад

Is that the same as the ECU reset?

@richcpz 5 месяцев назад

Do codes need to be cleared prior to doing this? Should I use my code reader to clear the codes? You state in the tutorial that if there's any codes present that need to be cleared ,( p0507 )

@gabrielquintero3338 Год назад

Is this still relevant with 2017 Nissan pathfinder?

@jafaary2614 4 месяца назад

my issue i do idle relearn car will go 650 rpm idle put if i shut car off and turn on it go back to high again .. any advise ?

@Ramzkilla1oz 3 месяца назад

Your battery is probably or too old. Otherwise the throttle body is bad or you didn’t do it right.. have your battery tested and report back

@GregRicci 10 месяцев назад

Sounds good I will try it

@dickhertz1823 2 года назад

Does this work on a 1999 Infiniti QX4?

@KingAmaniImani 3 года назад

Awesome information.

@Dougarony 2 месяца назад

09 Murano, has all the accelerate pedal sensor codes, replaced it and the Thottle body, I haven't been successful with any relearning processes. Any help? Should the codes still come up if I replaced it? My basic scanner can't erase the codes.

@DTUFINOPhotography 2 года назад

What kind of confirmation do you hear after the pedal relearn? What should i listen out or look out for?

@user-2Hteyasizyc 10 месяцев назад

A trophy comes down from the sky

@coverupcontest9621 9 месяцев назад

@@user-2Hteyasizycaye yo you a fool for that😆😆😆😆

@danielm.8499 3 месяца назад

Idle goes to 650 rpm

@966XXXXXXXXX 4 месяца назад

fully depress the accelerator peda Wait 20 seconds and Fully release the accelerator pedal within 3 seconds after the MIL turns ON (((((((((( NOT RUN in wait 3 seconds in stop MIL ) and ON

@michaelbotello8834 12 дней назад

This is so confusing i cleaned my throttle body and maf sensor and now it doesnt have a check engine sign but i tried the relearn and the check engine is not blinking when im starting the relearn test