Comparing Peerless Model 700-006 3-speed and Peerless 700-039 4-speed transmissions. Modifying Neutral Safety Switch to become Backup Light Switch. Showing MAJOR DIFFERENCES in Peerless Models.
Hi! What could be wrong with the Peerles 700 5 speed When the machine is running, it doesn't go overboard and shake the gear stick What could be wrong and where can I get parts ordered in Finland?
@BUILDNIGHT you think there’s any way to change the output shaft direction on these? I have a blower that had a dual shaft engine and I swapped to a single shaft engine so now the transmission runs backwards. I was thinking if I flipped over the gear that contacts the pinion gear it will reverse the rest of the transmission
Do you know where I can get one of these for cheap? I got a free cub cadet 1315 from a friend and it has a 12.5 that i got running and I want to build a fast mower for fun as cheap as possible. It has a peerless 920 transaxle in it but I don’t think it will hold up.
Odd question for a different application of these Transmissions: if you spin the input shaft one way the output shaft turns a certain way. If you turn the input shaft the opposite way does the output shaft likewise turn the opposite direction? Nice video, thank you very much.
These were in a lot of rear engine ride on mowers like Toro. They are great transmissions for go karts. Popular in racing mowers too. I made a homemade Lathe with one years ago. Wish I had video of that project!
Is the 700-023 interchangeable for the 700-039. I want change my 4 speed walk behind to a 5 speed for higher ground speed. They are both 36 spline is that possible?
Hey Metalman, got a Peerless 3628 on BobCat walkbehind. My drive pulley has managed to migrate out of alignment throwing my belt out of its groove. I can’t tell from manual what keeps shafts from sliding in and out? No set screws. I have a collar with grease fitting that will move away from gearbox when this happens. Thanks
Is it possible the circlip has worn the groove to be bigger than it’s supposed to be? I played with it last night and it seems like a wide groove, like over 1/2”. I was expecting circlip thick wide.
Look me up on Facebook. My profile picture has 2 race mowers in it. Please pm me. Rather do it that so we can keep it between us. Looking forward to hearing from you.., thanks for the reply back
I was thinking, you should just message me on messenger and not go trough facebook. Same picture. Just ay it's metalman so I know who's sending it.. thanks man