Powering Ham Radio on the Go: A Guide to Using Portable Power Station

Подписаться 18 тыс.

Просмотров 6 тыс.

50% 1

Find out more about the BLUETTI EB3A here: www.hamradio.co.uk/bluetti-eb...
MyDEL PS-1335 PSU: www.hamradio.co.uk/mydel-ps-1...
See all the Bluetti Range here: www.hamradio.co.uk/accessorie...
Running Order:
00:00 - Intro
00:50 - New MyDEL PS-1335 PSU
02:21 - Bluetti EB3A
Ham Radio Store: www.hamradio.co.uk/
Like us on Facebook: / hamradiouk
Follow us on Twitter: @HamRadioUK / hamradiouk

Наука

Опубликовано:

6 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 14

@hamradioop5777 Год назад

Hi Gary, I was a bit skeptical about the Bluetti PSU, but I found your excellent presentation to be mind changing. The phone charging and App control were pleasantly mind boggling features!

@Roppongidon Год назад

Looks really useful and well thought out. But I think Anderson Power Pole connectors would have been more useful to the ham community than these little sockets that always seem to have a centre pin that's the wrong size. So, time to get the soldering iron warmed up to make a patch lead, as I have just ordered an EB3A as shown in the video.

@ragheadand420roll 4 месяца назад

Just order the plugs male to male Cut in half and add andersons Then you have 2

@bruceroaf5750 Год назад

Hi Gary a nice bit of kit Bruce

@TheGazLab Год назад

yes its nice, ive ordered one of the big ones, will be useful in the summer.. and who know if theres any truth in the power cuts rumour lol at least I will have TV should the power go off.. LOL

@adam-g7crq Год назад

This might be handy for some repeater keeper's with a questionable mains power supply, if you can use the ups backup along with the 12v trickle charger might keep some repeaters on the go for a few hours, longer with the higher specked bluetti's.

@ragheadand420roll 4 месяца назад

I use a bluetti eb3a with a pyle 30amp ac pwr supply plugged into the inverter port Lets me use up to full 100 watts on yaesu 857 and since its a switching power supply it only draws heavier current when you use it

@greadore 8 месяцев назад

Interesting video. I wasn’t sure what the final verdict was on this. Does the radio draw too many amps if used in transmit mode too long? Is it safe to use?

@timdbl7804 8 месяцев назад

Many thanks for this info, Gary. Are all the Bluetti power-stations RF quiet?

@ragheadand420roll 4 месяца назад

Yes

@LeeShand Год назад

Will these portable power stations power an IC-7300 and PSU for POTA use?

@ralphwilmot6351 11 месяцев назад

Only as QRP on 10Amp DC longer via AC PSU. Worst interference on 160m from inverter.

@lesliephillips9240 Год назад

Does anyone know what the RF noise is like on these. I have a similar unit from a different manufacturer Yose. It's very good running my 705 but in the county side where the rf back ground is very quiet there is a very slight increase in the noise floor on the 705

@adam-g7crq Год назад

That's a good question, the 230V inverters are prone to be noisy maybe if your just using the 12v outlet that'll probably be ok. I just use a 12v lithium iron phosphate battery when I'm out and about smaller and lighter for my radios.