PushMowerRepair.com - Blade Boss Removal

Подписаться 10 тыс.

Просмотров 41 тыс.

50% 1

This video demonstrates how to easily remove the blade boss/adapter from a lawn mower. Click Below For More Information.
Visit our site for more tutorials, Parts and lawn mowers for sale, servicing avaliable!
www.pushmowerrepair.com/
Like Us On Facebook! To take advantage of specials and discounts / pushmowerrepair
All our content is offered free of charge however we have had a number of people interested in giving small donations as a token of appreciation for the time and money saved by learning how to repair there equipment themselves. If you are interested in making a donation it can be done here: www.paypal.com/cgi-bin/webscr...
Any donation is greatly appreciated. Thank you & good luck with your repairs

Хобби

Опубликовано:

29 июл 2013

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 19

@emeraldviking3637 11 месяцев назад

Thank you from Ireland 🇮🇪

@stevep2430 3 месяца назад

Tip, before refitting the boss to the shaft again, smear some lanolin grease to shaft where boss fits, will be easier to remove when the time comes again to remove.

@richardkarl6727 3 года назад

Thanks heaps mate. Though I had a real stubborn Boss.. Used lots of WD-40 and many solid taps with a Hammer finally got it loose. I hammered the boss on the cylinder body. Don't hit the top you can break it.

@brenttamatea7578 4 года назад

Good info thanks for the clip appreciate

@petermathews9298 10 месяцев назад

Thankyou

@BAK87 6 лет назад

Thanks mate, i'll make an improvised puller and try it out.

@peterream9437 5 лет назад

Remember to drain the oil , if you are removing the engine from the mower deck. As it enters the carb from the sump when turned over or to the side....many a good mower has been thrown away needlessly because of this, as it failed to start due to contaminated fuel. Drain oil and fuel, remove engine, do the work, replace oil and fuel and hopefully it all works.

@donbailey1281 6 лет назад

How do you change the spindle shaft on a Husqvarna push mower

@hajroselita 3 года назад

Where can i find an adapter like the second one you took off

@greenmanlove1 3 года назад

were did get the puller?

@sypher0101 9 лет назад

stead of using that little pin that's smaller than the threads, I threaded a bolt in and tried that (hasn't come off yet, think its rusted on).. is using a bolt a bad idea ?

@Pushmowerrepair 9 лет назад

sypher0101 Using a bolt is okay, but If the boss is extremely hard to remove it may be possible for the pressure on the bolt to damage the threads

@brianmott728 7 лет назад

I have a stuck blade adapter on a Craftsman mower that I used a 2 legged puller along with a bolt and it will not budge. I sprayed it with penatrating oil but it still wont move so what should I do?

@Pushmowerrepair 7 лет назад

Tighten the puller till it is quite firm then use a hammer to gently hit the blade adaptor, Tighten the puller and continue to tap the blade adaptor with the hammer, The Vibrations can help loosen the bond, If you have the means applying heat to the adaptor also helps.