Hi Fantastic products and you've revolutionized trail riding!! Thank you for that. I picked up a 2017 KTM 300 XC with the RadiusCX installed. I also have a 2014 250 XCFW with a Core EXP 3.0. I'm running your LHRB on both bikes too. Question I have is that the clutch lever pull (yes I still like to use it) on the 300 is extremely hard to pull, and I'm wanting to use it with one finger so I can also cover the rear brake lever. The lever pull on the 250 is a one finger pull with no issues after the EXP 3.0 install and allows easy use of the clutch lever with the index finger and the brake lever with the middle finger. How can i lighten the lever pull on the 300 so I can use it in conjunction with the LHRB. Its genuinely a 2 finger pull right now and extremely fatiguing to even consider modulating it. Thanks.
My Radius CX RMS 7913095 has the inner basket posts to tall ( where you screw the pressure ring bolts)and is not able to preload the Belleville spring, my bike is a Husquavarna FE 350 2019. shall I go ahead and paid for someone to shave off 2,5 mm+ or do you guys have a fix?
2023 KTM 450sxf doesn’t come with a tab washer stock…does Rekluse recommend using the supplier tab washer in the CX kit despite what the stock set up is?
@RekluseMotorSports At 3:53, when you press in the rubber dampers, it seem like your inner hub falls into place with very minimal effort. With 6 new dampers, this process seemed almost impossible.
How do you hold the clutch basket while tightening down that nut? I thought you needed a clutch basket holder tool to both loosen and tighten that nut? You did it with the bike in gear. I didn't think that could work and is hard on your gears, shift forks etc.
@@tomu1527 follow the torque specifications outlined in your installation manual. You can also reach us at (208) 426-0659 8AM - 5PM MST. Installation manuals can be found here: rekluse.com/support/