RTV Silicone Gasket Makers: Permatex Tech Tip Series

Подписаться 16 тыс.

Просмотров 197 тыс.

50% 1

Curtis Haines, Permatex Associate Innovations Manager, walks through the different types of RTV silicone gasket makers available to auto technicians, including the Right Stuff and Ultra Series product lines.
Featured Products:
The Right Stuff Gasket Maker: www.permatex.c...
Sensor-Safe Blue RTV Silicone Gasket Maker: www.permatex.c...
High-Temp Red RTV Silicone Gasket Maker: www.permatex.c...
Sensor-Safe High-Temp RTV Silicone Gasket Maker: www.permatex.c...
Water Pump & Thermostat RTV Silicone Gasket Maker: www.permatex.c...
Automatic Transmission RTV Silicone Gasket Maker: www.permatex.c...
Gear Oil RTV Gasket Maker: www.permatex.c...
Ultra Blue Multipurpose RTV Silicone Gasket Maker: www.permatex.c...
Ultra Black Maximum Oil Resistance RTV Silicone Gasket Maker: www.permatex.c...
Ultra Grey Rigid High-Torque RTV Silicone Gasket Maker: www.permatex.c...
Ultra Copper Maximum Temperature RTV Silicone Gasket Maker: www.permatex.c...
Ultra Synthetic Gasket Maker: www.permatex.c...
Please call 1-87PERMATEX (1-877-376-2839) or fax 1-800-432-2067 with any questions or comments.

Опубликовано:

10 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 77

@uptownsamcv Год назад

I used Permatex Ultra Gray on my Maxima's oil pan 10 years ago and till this day I have no oil leaks whatsoever. It's really important to prep the sealing surface real good and allow plenty of time for the RTV to cure. I always give it 24 hours before exposing it to any oil..

@shariqhussain473 Год назад

How about ultra back? I am going to apply on oil pan. Is it good enough?

@kellismith4329 Год назад

@@shariqhussain473 yes the ultrablack will work

@Bawkr Год назад

Also don't squeeze the surface down too tight. Need to leave room for the seal to form if you squeeze it down too far it will never seal. Best to lightly tighten like quarter turn or less then when it dries most of the way hit it with torque spec. About 5-8ft lbs depending on vehicle, these pans are actually easier to do with a in lb. setup but a lot of people wont have anything to measure that.

@uptownsamcv Год назад

@@Bawkr I usually just fully tighten but let it cure for 24 hours before adding fluid to whatever it's sealing, never had a problem. that's pretty much what the factories do, no time to wait on the assembly line...

@Bawkr Год назад

@@uptownsamcv Never had any luck getting it to seal unless I let it setup first. It would squeeze all of the filler out making a nice big leak or multiple.

@nothanks5652 6 лет назад

holy crap that's a ton of rtv on that oil pan lol

@420holidayholiday9 6 лет назад

No Thanks im not even a mechanic and that's exactly what i thought lol

@justinrogers1988 4 года назад

My thoughts exactly lol!

@arincstingray611 4 года назад

They are gasket maker ... But the way they apply it just wrong... What the company ...

@VisionsTruth 3 года назад

The bigger the gob the better the job : D

@numbnutsAU 3 года назад

that's how you destroy FA20/4U-GSE engines lol

@chilledboost1982 2 года назад

The ultra synthetic gasket maker... the only thing i have found to seal the timing covers on the Ford v6's

@hdcat61 Год назад

Be sure to mention that the closures on the Tube RTV products fail consistently, and that the company should change the design or the material to eliminate the problem!

@DanzZerous 2 года назад

373cc high compression gas engine, water cooled, for crank case, suggest me the best please

@Mikzone-zb6jk 3 года назад

I love gasket makers 💘

@dalegribble60 7 лет назад

Hey Curtis! Will The Right Stuff harm rubber in any way? Thanks!

@sethmorton1856 7 лет назад

Great presenter.

@romanjanke5923 4 года назад

Hello! I've used for Mitsubishi 4G64 GDI engine Permatex Ultra Grey for cylinder head upper surface. It holds since 3 years: no leaks, no troubles. But as i yesterday "opened" used oil filter i've seen some remains of this sealant in there! Could synthetic blend oil dissolve RTV? It's Eurol Super Light 5W-30. Thanks!

@Integrity.is.everything 4 года назад

Im confused. If im using this on a timing chain cover, do i use the Grey, blue, black, blue synthetic or Right stuff?

@matthewvasquez9278 3 года назад

Yeah I do know ultra Red TRV is good for that, I have a R107

@albertoroque8125 4 года назад

Can I used the ultra black on on a head gasket on. Outboard motor,,saltwater leaking all over the place,,,,thxx on advanced,,

@5jjt 6 лет назад

Which Permatex product for a transmission pan that needs to be driving as soon as ppssible. In other words, which product to use if you can't wait the 24 hour drying period? Thank you.

@knighthawk1784 5 лет назад

none. you never use a gasket sealer on a transmission pan.

@matthewvasquez9278 3 года назад

KnightHawk yes you need to get a normal gasket and put it on dry

@facegodpoe2995 3 года назад

Can I use this on my cub cadet model lt1042 series year 04 type?

@TankDavisConquers 2 года назад

Good spokesman

@rinkuranjit9157 Год назад

For small engine repair. Which one rtv best. Small engine like Vespa scooter? Anyone can help about this ?

@kellismith4329 Год назад

Ultra grey

@DanzZerous 2 года назад

Don't know why choosing the right gasket maker is difficult now

@kellismith4329 Год назад

There’s always the actual gasket

@DTUFINOPhotography 2 года назад

Can Permatex Ultra Black RTV also be used along with a metal gasket?

@kellismith4329 Год назад

Yes clean surfaces well with acetone

@franklinmontero017 2 года назад

for the engine or transmission crankcase, should you use ultra black, or could gray work as well?

@kellismith4329 Год назад

I prefer grey but either will work

@5jjt 6 лет назад

Permatex, which transmission gasket-maker product should I use if I want to return my vehicle back to service ASAP?

@davebacknolaliki1452 4 года назад

“Right stuff”

@diegomr6969 7 лет назад

hi friend! im from argentina, an i have honda bike xr250r 1995, and my surface of my cilinder and cilinder head It's misshapen. i can use this producto (silicon permatex ) on these surfaces?? include the gasket for more result¿ ty

@Christophernice724 4 года назад

Im wondering the same thing but I may not get an answer either

@kellismith4329 Год назад

Depends on how mis shapen it is, you can try

@Devo1987 5 лет назад

If you can get your hands on a gasket buy it !! If you have no access or cannot wait for a casket and have the RTV use the rtv I personally like the gasket cuz there's a lot less messy and I've never had a problem !!!! Blue pill or red pill ha

@richieschmidt6225 5 лет назад

Devo no way man. Some of my cars used a cork gasket on the oil pan from the factory and it’s TRASH.

@putheflamesoutyahoo1503 2 года назад

jb weld sealed the rust oin oil pan should work for gasket

@samreensiddiqui7096 4 года назад

For where we get this ?

@economico2313 3 года назад

hey which one should i use gor plastic intake manifold?

@permatexvideos 3 года назад

Yes absolutely. Check out www.permatex.com/products/gasketing/optimum-gasket-makers/permatex-optimum-red-gasket-maker/ for more information.

@liangmaew 3 года назад

@@permatexvideos Thanks for the video. Any one could be used to seal the leaking from the power steering pressure hose (the joint between the rubber and metal parts)? Thanks.

@kellismith4329 Год назад

@@liangmaew no, super high pressure replace hose

@VisionsTruth 3 года назад

I think my walmart only has 3 maybe 4 of these lol

@usmcdoc2512 3 года назад

How do you keep it from hardening?

@harisyoung4110 2 года назад

after open keep it inside refrigerator, works well for me.. have the same tube from the last 4 years that can still be use and not hardening.

@usmcdoc2512 2 года назад

@@harisyoung4110 4 years!? I stuck plastic on top 5yan put the cap...... Doesn't work 🤣 gotta pick at it to get the hardened layer off.

@Therey1898 5 лет назад

Can it be used on valve cover gasket??

@whichdoctor4858 5 лет назад

Therey1898 RTV Red high temp.

@putheflamesoutyahoo1503 2 года назад

They all work if you sell the car fast...oil pans are just made stupid. Channel in block w o-ring??hello?

@chaysendreamz Год назад

Yo anyone else see how much right stuff they splooged into that Subaru oil pan? 😂 💀

@kellismith4329 Год назад

Floating now ready for the pickup screen

@georgettecastillion 5 лет назад

💙💙💙

@melindaortiz9741 3 года назад

Am more confused

@mariogarcia1803 2 года назад

Theres 0 tips here

@juandediosmendozamaradiaga2853 2 года назад

explicación en español

@mariogarcia1803 2 года назад

Zero infor

@DjCyriss Год назад

It usually takes me 4 tubes to seal my oil pan too lol. Ohhh, you want bread with your mayonnaise sandwich 🤣🤮

@nathanmciver6496 2 года назад

Man thats low! Unrelated, your telling me they sell gaskets and some are crap from experience, and this video says no gasket is needed and this works better! If so, they shouldn't be selling people crap gaskets

@kellismith4329 Год назад

Or crap in a tube that doesn’t work, or cars that leak to begin with

@bobswagger8996 6 лет назад

Tech tips?

@imgonnagogetthepapersgetth8347 5 лет назад

It's kind of like 80s wrestling. You had the champion, then you had the state champion, the national champion, you also had the intercontinental champion, the intercontinental WORLD heavyweight champion, and the Universal heavyweight champion.....you also had the WWE, WWF, WWW, WWWF the WCW, Georgia championship wrestling, NWA and WTF variants of each of the above champions and you had the tag-team equivalents of each as well......all of which were bullshit.....all of these will leak.

@Nicole-hg6dr 4 года назад

papers, your post started to take me back to my childhood, and then not. You made some big claims, I hope they’re from your personal experience with every single RTV mentioned/picture.

@specialized29er86 5 лет назад

Only use the Permatex products none better.

@4418CARLOU Год назад

Who is the clown applying it at 28secs? Stevie Wonder could have done it better. That will seal the oil way resulting in a scrap motor!!

@richarda3659 4 года назад

You never even said what RTV means. You literally left out the single most important piece of information. It always amazes me how company and sales people drink so much of their own kool-aid they become clueless how they sound on the outside.