Simple & Cheap Festool Storage 

This is a great idea! Just found your channel and subscribed. Your uni-strut video popped up in my feed this morning. (An equally good idea. I think I might combine both ideas and hang the threaded rod cabinet from some uni-strut. A tip for cutting treaded rod and repairing the thread ends is to use a thread cutter pre installed spin it off and repair the thread. I recessed a couple of thread cutters into plywood discs and then use either a small belt sander or drill press rubber sander attachment in a drill and spin them off and it repairs the thread. You can do the same thing with a just a nut but the nut won’t last long. I noticed you gang cut your thread rod so nuts would be the way to go… If you use threaded rod couplers (extensions) I would recommend using an extra nut on each side of the coupler as lock nuts. See my tip above for spinning nuts on quickly. I would use the rubber drill press attachment for that so you don’t damage the threaded rod or round off the nut. You can also just attach a drill to the end of the rod and spin that if the rod is short enough, or if you have a helper. I use and old drill I don’t mind chewing the jaws up on or I will slip a short piece of tubing over the rod to protect my drill jaws.

I can't stop picturing actor Zachary Woods' (Gabe on The Office, Jared on Silicon Valley) face hearing your voice as commentary.

Genius idea. Love that they're adjustable.

Those are some nice storage boxes!Nice build 👍

That's a smart approach to that type of storage!

Great idea, thanks. For high speed nut positioning you could use a drill fitted with a round plate covered in rubber or similar non slip material.

Spacers between the levels would be more stable. Particularly if you were to cut the shelves to accept them. And it would cut the number of nuts in half.

I actually enjoyed that build and might make it. Good job. Oh...and....you mentioned the file for the CNC? If you don't want to give that out I understand.