SUR-RON WIRING HARNESS EXPLAINED | SURRON DIY BUILD FROM SCRATCH 

Omg amazing vid this helps my horn problem a lot! Thank you dude! EDIT: I also found your review on Ali rn. Great job!

Thanks had the key and headlight mixed up on accident this helped!

Hey man THANK YOU for this video. I am going in blind trying to repair someone's SurRon X that had no throttle response. Found a couple sheared wires on a mystery connector by the motor and hey guess what: Hall Effect Sensor connector. Much appreciated!

This helped a lot man I really appreciate it

how great is this 😍

Really helpful video

Great video btw Is there away to extend the plugs that goes to the controller? Thank you..

Great video! Really helped me with my edirt bike build!

thanks you this helped alot

Dude.. I love you.

Hey coolwatts! I was hoping you could help me. So I’m using all surron wiring for a non surron build. And had a question. The “battery in” connector the small grey one. Is that connector the equivalent of positive and ground ring terminals to give the harness power?

Hello, maybe you could help me. I want to install a new taillight, it has 5 cables, 2 is for signals, 1 positive, 1 negative and 1 for the brake light. the signals I don't care about, the positive and negative is obvious, where do I need to add or to weld the brake light for it work when I'm pushing the brake levers?

Where did you get the frame??not available in Scotland

Does this still have the green loop to cut to derestrict the bike? by the top of the battery

What’s the link to that ali seller you purchased this from ?