Team Z Motorsports Anti Roll Bar Install 

This is great equipment. I use all of their products for my suspension from anti RB to K member. AWESOME customer service too! Thanks Team Z

does welding in the top bar encourage rust after a while

Could you bolt it in ?

Can the roll bar be used on a street car that I use on a track sometimes on a everyday driver

How much degree the linkage must be ? I saw put a machine to see the number

How far forward is the roll bar from the rear end housing?

Nice video thanks!

This is NOT for corners. Keeps the car straight during a drag race. Do not put this on your car and carve a corner. You'll snap the end links in 2 seconds.

Does team z offer install of there products to customers ?

Can you drive on the street with this set up?

When you weld on a tube it bends the tube. using heat or weld is how a bent tube is straightened he just gave the car toe out which is not good (it screws up the handling) at all if he had welded it on the front side he would have given it toe in which is fine. A clamp on bracket with the tab on the top or bottom would be the best, I work in a machine shop is how I know.

Unfortunately this wouldn't work with my exhaust set up..🥺

So you only put preload on the passenger side link?

What kind of welder you using

Location

Please get rid of that harbor freight welding helmet..but great vid ..

I may have enjoyed the video IF you had shown the set up watch a good camera angle and a good video. This might as well have been taken from the street in front of this guys shop. It showed almost nothing but two guys talking. Not worth the time spent watching it.

reduces roll during corners, in a nutshell.

this looks so flimsy and pointless. I see how it works, but there are a lot of better ways of going about it

this looks so flimsy and pointless. I see how it works, but there are a lot of better ways of going about it