Our S-10s have almost the exact same setup and I'm going to add an antirollbar later this year so I'm anxious to see how well this works out for you. Keep 'em coming, brother!
I want the same kit 👍🏻 My buddy with the white wagon uses a similar system and he puts it on the bumper 💪🏻 one thing I did see was that long bar bent so it shows it’s working ! Nice job 👍🏻
Good content. Just built a budget 91 s10 drag truck and looking to put a anti roll bar on it. And doing it with poor man welder to yes sir. Weld my solid engine mounts in with one. No cracking after a season
Have faith brother it will hold, I 've had some sketchy looking mig welds in odd angles and they always hold. In the end the only one you have to get approval from is you . Practice makes perfect 👌
I bought my flux core welder for exhaust work only it really surprised me the other day I was on a muffler on a Concrete pump and I needed to weld a sturdy bracket to the frame I was thinking about pulling the stick out but I said no I'm just going to turn this little thing up and see what it'll do I had to turn it down some I had it on high number one about 4 and 1/4 wire speed and it did great on quarter-inch inch no problem high #2 was blowing holes
Yeah they work well for what they are. Almost everything I weld is outside so it's a must. Exhaust with Flux-core is tricky my Lincoln is getting old and heavy compared to the DC welders Im going to pick up one of the titanium DC welders soon.
@@TPVPRO when I picked out my flux core welder I bought the biggest of the little ones when you're buying cheap tools always pick out one a little bigger than what you really need I picked the 240 volt I got a long wire I plug it into I can go all over the pole barn all over the slab on one side and all over the first parking spot on the other side and I just pick it up and carry it when I have to bring out the stick it's a big cart huge long cables 5 different boxes of welding rods all different sizes
I love your content... I'm working on my S10 suspension now.. Do you have a part number for the anti-roll bar, and was it a special order item? Thanks....Jimmy T.
Have to admit that's the best i've ever heard a flux core welder sound. I'll be installing the same anti roll in my truck. I cheat, I have a 100% duty mig welder that makes me look like I know what i'm doing. lol
I'm welding an anti-roll bar into my S197 Mustang tomorrow with a flux-core welder, I have confidence!! Is yours still holding up good, did you get your track times you was after?
Do the arms have to be at 5-10 degrees??? I’ve seen a lot of other guys run them straight/vertical before. My manufacturer didn’t send me any specific instructions unfortunately.
It must not be completely straight when you welded it together. Just move it up and down a bunch of times without grease in the bushing with everything tigh remove and clean out the material that came off. Also lightly hit it with 150 of 200 grit sandpaper until it moves freely but do it nice and slow in order to not over remove material. Then add the grease when it's moving freely.
I'm putting something like this on my rig. id love to get the results of the trial! I heard you want to be careful of you drive your race on the road with this style of bad because it'll pull the inside wheels of the road.. true? HELP!
that's not an anti-roll bar that's a support brace. there's a reason anti-roll bars have u-shaped or a bend in them it's so that it will flex under load without flexibility it does not allow the suspension to balance around cornering.
Ok then talk to TRZ that is what they call it and like everyone else in drag racing. "We go straight" Are you sure what you are describing is not a anti-sway bar?