I dont know what you all are talking about with errors. I ordered the blue LEDs from Jesse Dean last week and i just got done doing this installing them today. I did exactly what this video said to do. Verbatim. It works flawlessly. I couldnt be happier with the result. It only took about 30mins. Now that I did it once, the other turntable will be way quicker. I would warn you to double or even triple check that you're putting the negative and positive on the correct side. You dont want to fry your turntable!
Can any one help be for a mess up my secod target light...... i never snipped the resister!! when plugged back in my led blew straight away :( my negative wire i soldered onto the bottom pin my positive wire soldered onto the orange lead all that said i never snipped the resister!! so when i plugged backin the led blew.... if i cut the resister in thesecond one and follow the same steps in the video will this solve my problem?? THANKS IN ADVANCE FOR ANY ADVICE OR TIPS
So with these LEDs there is not voltage regulator, dedicated resistor, etc. needed and I can keep the cabling on the connector to the circuit board etc. as is?
Jesse, have you guys or do you guys make RGB LED light strips to light up underneath the 1200-M5G platter? Because if you do i would like to purchase that from u guys if you did make them. I mostly see European sellers, but thats way too expensive to purchase plus shipping. If guys don't make them you should consider it, i bet a lot of people would like buy that and not having to solder it in place!
itimmy101 hi there. Not sure in what part of the world you’re located but I found another seller it’s good as well Go to EBay and look under icecoldcustomsusa1200 He has 100% positive feed back. I’ve purchased from him in the past. LES’s. And they’re good. Give it a try. They’re located in Cincinnati OH
@@rsanchez7111 i reside in California, yeah I've seen these guys but it requires soldering which I have no experience in...this is why i asked the jesse dean dudes since they make pre assembled products that doesn't require soldering.