No video :(

vespa driveshaft SERVICE GUIDE | FMP-Solid PASSion |

FREAKMOPED Vespa Tuning | FMP - SolidPaSSion |

Подписаться 23 тыс.

Просмотров 35 тыс.

50% 1

HOW2 service the driveshaft: Toothing, bearing seat, selector rod, cruciform, gear sprockets, distancing. Its a px lusso driveshaft.
#vespa #driveshaft #service
--------------------------------------------------------------------------
FOLLOW me on
insta: @FreakMoPed
fb: / freakmoped
--------------------------------------------------------------------------

Опубликовано:

25 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 18

@charcoalacab7065 2 года назад

Last photo is impressive!!!!! how many times have you opened a vespa engine?!?!? 🤣

@FreakMoPed8 2 года назад

maybe 1,2,3 times or so 😉😉😉

@gabeanderson6594 2 года назад

I was wondering if you checked shafts for true. Mine has .004“ (.10 mm). This is measuring the selector box side with the shaft installed in the large side of the case. Many thanks.

@FreakMoPed8 2 года назад

no i dont. wouldnt measure it in the engine though but in a lathe

@albertomoreno8230 Год назад

Da igual la posición de la cruceta ?

@FreakMoPed8 Год назад

@helike13 2 года назад

What are the right clearances between the gears?

@FreakMoPed8 2 года назад

U only need to check the outer tolerance towards the ring. , not between the gears. 0,1-0,2mm it shall.

@imlyshawn3690 5 лет назад

Hello mista freakmoped need some help, can you please tell me y my vintage vespa's 3rd gear slips?

@FreakMoPed8 5 лет назад

1) tighten cable 2) check/replace gear selector rod 3) open engine and exchange cruciform AND check the inside of the gears

@imlyshawn3690 5 лет назад

@@FreakMoPed8 thank you 👍

@eunomeener1496 4 года назад

Ive got a problem with my vespa. if give it a full throttle it bogs down or wont accelerate at all (especially when im speeding)l. Is there a way you could help fix that.

@FreakMoPed8 3 года назад

idle jet setting and clean it in general, sorry didnt see the comment

@lusso9723 5 лет назад

Hey mr mista!! How are you been?? Oh men, last night i was driving my vespa, and suddenly the rear wheel got stuck and I almost fall. And at that moment the rear wheel doesn't move, neither backward nor forward.

@FreakMoPed8 5 лет назад

seriously? hopefully u didnt got hurt. seized cyl?! whwats your setup

@lusso9723 5 лет назад

Watching these video i guess something bad could be happened with the driveshaft. ;( The engine start ok. But the kickstart it's stucked... :(

@FreakMoPed8 5 лет назад

if the cyl got stuck the kickstart is blocked. pulling clutch and the kicker should work. if not, sthg is blocking the gearbox

@lusso9723 5 лет назад

@@FreakMoPed8 in my case my vespa start with the electrical starter. But the kickstarter I can't because its completely stuck. Also I can't change gear even i pull the clutch.