Zan, imam vprašanje zate...ali se tehnika hladnega lepljenja uporablja na aluminiju in na vseh delih avtomobila (streha, hauba)? Lep pozdrav iz Bosne in Hercegovine, Hvala
Nice,Glad to see you making more videos..I know you've been busy with training and your shop work Can you give us an update did you win this year at M.T.E?
Thanks so much for all the information and skills that you share! With small creases it looks to me like your knocking these down on each side at the the top and bottom of the crease to remove the straight lines and make the dent round. Straight lines lock in pressure where a uniform dent can be compressed while lifted up. Am I on the right path?
Brilliant job and a pleasure to watch. I like the top half of your stand but concrete just ain't heavy enough for you base. Would suggest you make a base out of repurposed gym weights. Also makes the stand easy to move because thay are round allowing you to tilt and role. Great work.
One question. Sometimes when I push and about to finish the dent in left with like some push marks in the upper side of the panel how can I prevent that from happening?
I want to learn this so bad. Good thing i got the tools even though it was cheap from amazon. I hope i don’t give up. By the way Sir, i love the videos so far the most basic i have seen and very easy to understand, Of course i will subscribe ❤.Thanks for sharing.
Wow you are a true PDR master Zan, that looked absolutely flawless! I hope jobs like this are profitable for you as that is a lot of hard work and should be rewarded generously! Hope you are well my friend 👍
Hi i have big dent on the center of my car trunk and trunk is not opening I asked car care and they said we need to replaced the whole trunk its gonna take $1000 from my pocket please give me any solution to fix it without replacing?
Hard to say anything without seeing the dent. However if it’s not opening it must have bent the structural parts of the trunk and it might be better to replace
Do you think that an Amazon PDR dent pull kit (SuperPDR) is good enough for a starter kit for a beginner? I noticed that the tap downs is a hard plastic. I’m thinking about giving it a shot. The kit is just for glue pulling only, no rods included. Is there a better less expensive kit for beginners to start with?