I feel a lot of us old piolets got sucked into 1000 + rates back in the day because of how bad clean flight and early betaflight was. Spinning fast was smooth back then lol and sometimes when doing a smooth slow roll would send your fc into a crazzy flip out mode. Back in the day if you even bump a small branch your drone would flip out and fall out of the sky. People forget how bad things where back in the day lol when frsky was god lol lol
Wait wait wait, I tried to do the backward flying but my drone does not respond like yours does! How can you only use yaw to turn around? If I try to turn then I have to use roll also to have a flat turn. How the heck is yours setup??
Yeah the 540 60 is insane i can loop my house and get a few speckles. Im used to 1.8w analog transmitters and they go black & white and warp going around house.
Hey, great video! I'm intrigued - will this setup (Walksnail VRX + Accsoon Seemo + iPhone) actually work? Could you share more about the connection, battery life, HDMI quality, etc.? If it pans out, it could indeed be the ideal minimal setup for those without goggles.
I have three quads with HDZero, and would have more if it were not so damn expensive! I probably purchase at a ratio of 10 to 1 in favor of analog! I purchased HDZero with the hopes that as more people jumped on board, the cost would come down. Never happened!
Go pro11 mini is a fkin piece of shit! avoid it at all costs. Seriously there are people who bought it and got it glitched in 4 days. Mine went out after 2 months. After that all it does is just freeze even before i start recording. All u can do is either wait for batter to run out or reset it. But then it freezes right after u try to use it again. It was my first and last gopro.
Hi!! I just put together and flew an old plane BIXLER II with at Speedy Bee controller, the 405 FC. with INAV 7.0. Everything worked very well. GPS, RTH. but Autolaunch. Everything on the OSD is working, I get the System status indications, "Move the throttle up and launch", however the motor does not get to IDLE. The system is prompting me to hand launch, but I did not since the motor was not idling, not spinning at all. I noticed that in normal conditions the motor starts turning when the Joystick is at 25% approx. The CLI commands are: Launch Thr 1750 Launch idle Thro = 1300 Launch Velocity = 150 Launch Accel = 1500 Launch max angle = 180 Launch detect time = 40 Launch idle motor delay = 0 Launch motor delay =100 Launch spinup time =100 Launch end time =3000 Launch min time =0 Launch timeout =10000 Launch Max altitude =0 launch climb angle= 18 I guess I am missing a setting, or there is something with the throttle setting since the motor starts spinning up at 25% of Joystick in manual mode Let me know if you have suggestion
its all good you may have learned since then, yes i can dis arm and re arm all time in air and you must have a error on screen why it wont arm may be a navigation or flight mode error try going back to acro or manu to arm with no nav modes like loiter or auto trim or auto tune. good flight and video!
can you make video on max load 4 chanels ? becouse i bought 4ac before monts and it was big trash, weak lines, caught on fire with external power and 4 chanels with 4cels on max load and thats not cool
I would just use the stock antenna and for long range use the elrs 900 mhz module, at least i will when I save enough money to buy the Radiomaster Boxer Max edition and the battery
So I haven't flown in about 3-4 years now. Recently got a DJI HD setup and built some new 5"/6" quads. So BF changed how rates are now? I'm guessing I just need to use that calculator to figure new settings like my old ones? I think I was at 1183 with 0.73 expo. But I do plan on adjusting them more tighter to my flying now and take a bit more seriously in setting them.
I'm getting into FPV again after a 10 year hiatus. (Got too expensive and frustrating modifying and fixing my old drone, which is now a museum piece.) I decided to go all in on Walksnail. Got the Goggles X and now waiting for my Walksnail-proloaded BNF quads to arrive. Anyone know of any BNFs for sale that have the Moonlight 4k or Avatar PRO systems pre-installed? I decided on Walksnail because 1) those goggles look amazing (I love the LED eyes); 2) I want something good in low light or night time flying; 3) picture quality more important than latency, I am not a racer; 4) good penetration, maybe even the best for long range; and 5) it's not DJI.
