First of all, I owe a HUGE Thanks to Benji at Treatland for going out of his way to help me out with this.
Video covers Installing the Treats "puch 70cc 45mm reed valve kit especiale",
www.treatland.tv/puch-70cc-re...
Puch Polini Reed,
www.treatland.tv/puch-polini-...
Rear facing Weakends Puch Reed kit VM intake,
www.treatland.tv/WEAK-ENDS-in...
And a Mikuni VM 20mm Round Slide Carb.
www.treatland.tv/mikuni-20mm-...
I set my ring gap at just a slight drag on a 0.007" feeler gauge for the upper ring and slight drag on 0.009" for the lower.
I chamfered my ports a little with a dremel to prevent the rings catching, but no case matching.
Here are the Moped Army pages that I used -
Kit Install
www.mopedarmy.com/wiki/Install...
Ring Gap
www.mopedarmy.com/wiki/Ring_gap
Last part shows attaching exhaust studs and Kickstand with spring and finally mounting the Engine in the Frame.
26 сен 2013