2005 GMC Sierra 1500 Neutral Safety Switch Replacement 

Thanks dude. After spending many hours trying to figure out why my 05 Colorado won't start period, I've made it to the neutral safety switch myself. And with the clear help you just gave me in fixing to finish removing my neutral safety switch and repair it and fingers crossed it'll crank up!! Thanks for the info

Cleanest 05 Sierra I've ever seen.

Thanks for the info and video. I have to replace it on my Yukon. Same issue.

your trucks clean as hell and if anyone has this problem and you need the truck to crank hold the key in start and slowly pull down the shifter into reverse and sometimes it will crank if switch is going bad

U skipped the only part of video I needed

Great video...thanks!

really very good video. good explain.

Sure wish I could have seen you unplug the harness and plug back in other than that very good information thank you

Very helpful.

I ask because I'm throwing "p0706" but don't have any issues starting or maintaining driveability. It's described as "transaxle position range/circuit range sensor". I'm not sure if I need to change this post from your video or not. Thanks for trying.

What's that ring behind the arm that you're adjusting toward the end of the video?

So did it start up after you installed the new switch?

I just wanna know how you got the harness back on because I can’t get my harness to go back in

I have the same truck new battery and alternator .no power. And no crank all deid . any advice ? Thanks 👍

How tight did you torque the bolts?

hey buddy, very good video. did u throw any codes before u decided to change the safety switch?

Where is the output speed sensor at?

How do you take the plug off?

Do you oír it on neutral or can be se on Parking

So your truck didn’t start even if you put it in neutral?

Is this the “shift position sensor”? I’m looking at buying an 05 Silverado single cab and the guy says it needs a “gear shift sensor”. Says if you throw it neutral it’ll go tf??🤔

could this cause for my back up lights o not work on 02 avalanche

Where is your drive train? I got under there and had about 1/2" to work and couldn't get to the bolts because the drive train runs right up against it on a 2002 GMC Envoy. Do-it-yourselfers beware!

Can’t get it into neutral

only replacing its nothing

Why are you whispering??? Speak up