Cut an Object Larger than your Laser Bed Lightburn Easy setup 😲 Oversized Projects 😲 Pass Through 

Brother, everytime I am in a need of something not so trivial in lightburn, you come and deliver! I wish you the best!

Thanks so much for the easy to follow step by step video. I have been so confused with others. I just cut my first oversized 600mm circle. Thanks Legend.

When you're good, you're good. Thank you for lesson. Well done.

Terrific! Just what I needed...

Great info, thanks for sharing!!!

Another great video!! I would have never thought of this!!

Nice one!

Thanks for making a nice, short video

Thank you for this video, i needed to cut a 24" circle and my bed size is 20x28, this helped me so much and i actually understood the process because you were to the point and clear about the process. I had just one end come up a little short but i sanded it and you can't even tell. My red dot was off a tad so i know what i did wrong.

Great video, just was not clear on after you make the nodes, how do you get the circle to cut in half, i have tried what was suggested, but the circle does not break.

If i dont put material straight will this method realign design to cut properly?

Great video But does this work with rdworks v8 programe

Why do you send and not hit start from your pc? Just asking.

I been trying to do this with a logo and image and for some reason i can't get it to work. When i make plain circle yes but with a design or a logo in the middle i can't do it the Edit notes doesn't work only on a plain circle. I can i get to work with a design in the center and then flip it and continue the design? Thanks