Cylinder Honing A Continental O 300 Cylinder

Подписаться 2,5 тыс.

Просмотров 8 тыс.

50% 1

Cylinder honing a continental O 300 cylinder in our cylinder hone. O 300 cylinders are one of the smaller bore cylinders that we work on in the shop. In this video you will see the process that goes into working on these cylinders.
Check us out online and on instagram :
www.alaskaaircraftcylinders.com
/ akcylinders
We hope you enjoy our videos, thanks for watching!
We are a small aircraft engine overhaul and machine shop located in Wasilla, Alaska.
***This video is meant for entertainment purposes only and should not be used as a guide. You must be a certified mechanic to perform this operation following only the applicable manufacturers instructions.

Авто/Мото

Опубликовано:

16 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 16

@jiyushugi1085 Год назад

Has anyone ever checked the perpendicularity of the bore to the cylinder flange surface and found it to be off?

@tayseerismail3206 3 года назад

Hooked new subscriber. Keep up the good work A/P IA from San Antonio, Texas

@andylewis210 10 месяцев назад

please republish without the background music

@azapman38 4 месяца назад

There are a lot of fault... There are two measurements point for cylinder max wideness.. And also where is your measurement tools calibre tag ? Which authority authorized you ?

@maximolopezsr9399 2 года назад

Excelente instruction videos, what type of stone used and Grids please

@josegarcia-ww6dq 2 года назад

Hello 🖐🏻👍🏻I have seen the video, I think this is good I do with the three-legged burnisher, with pneumatic pressure, what if I want to apprehend is to make the measurement of the barrel of the cylindro, what should I have to do it? And another question after the burnisher I must pass some special sandpaper, because the face of the cylindro is opaque by the friction of the stones of the burnisher, thank you ...

@maximolopezsr9399 2 года назад

I have a question ,,when you honing for example ,chrome Cylinder do you rechrome it or what

@maximolopezsr9399 2 года назад

When you hone a. Chrome cylinder do you rechrome that cylinder because chrome will cover about 0.001 let me know please

@maximolopezsr9399 2 года назад

When you hone a Nitride cylinder what happen with the 0.010 on the know the nitrate

@theanimatedadventuresofcho4395 3 года назад

What model machine is that? shes beautiful

@fightinggravity9591 Год назад

That doesn't account for a choked cylinder. How do you hone a choked cylinder?

@akcylinders Год назад

Hello! Good question. Honing process for a choked cylinder is actually the same! Choke is only a few thousandths so the stones will be a little tighter in the choked area of the bore, but honing doesn’t take very much anyway. When we BORE the cylinder we can adjust the stroke of the stones so we can get a different dimension at different depths. Thanks for watching 👍🏻

@shuanahmed2033 3 года назад

What is honning?

@akcylinders 3 года назад

Honing is a process of conditioning the surface of the cylinder wall to help with lubrication of the piston rings during operation. Honing creates fine crosshatch imperfections on the surface of the cylinder bore. You can think of these imperfections as peaks and valleys in the surface of the metal.