How to retrofit projector / puddle lights to Audi A4

Подписаться 57 тыс.

Просмотров 8 тыс.

50% 1

Step by step guide on how to retro fit projector / puddle lights on a 2005 Audi A4 estate B7.
Check out the diagnostic machine I use - diydaly.co.uk/products/phoeni...
Any Donations to help Support my Channel are much appreciated.
Donate via Paypal - paypal.me/diydaly
Puddle lamp set including wires - ebay.us/VtZeZf
S-line projector lamp set - ebay.us/ECeL9s
Audi badge projector lamp set - ebay.us/WYamjI
Tools Used :
Sykes Plastic trim removal kit - amzn.to/3pcUl9N
3/8 Drive Mini Impact driver - amzn.to/3iFCZ30
Snap on small flat screwdriver - ebay.us/MDgNAY
Ring Inspection Lamp - amzn.to/3gGWHcG
Main Soldering iron kit - amzn.to/2N9A7k5
Gas Soldering iron - amzn.to/37sMnCZ
Screwdriver set - ebay.us/NUu3Q1
Heatshrink selection - amzn.to/3bhOxGT
Mains Die grinder kit - amzn.to/2ZAjyQB
Battery Dremel die grinder set - amzn.to/2ZrCWiX
Automatic wire strippers - amzn.to/3jZkg3w
Wire snips - amzn.to/3s4hDjE
Insulation tape - amzn.to/3pyPYFY
If your looking for reasonable price car parts check out these sites:
Check Euro car parts - tidd.ly/3lIO7xA (use discount codes on site)
Check GSF Car parts - tidd.ly/34pZe7o (use discount codes on site)
Wiring Info :
Front door:
Wire with pin goes into pin 13 (up to 2007) or pin 17 (2007 on)
Wire without pin ties into pin 21 (brown wire)
Rear door:
Wire with pin goes into pin 2
wire without pin ties into pin 6
If your loom doesn't have a wire in pin 6 you will need to get a replacement pin from Audi and clip it into pin 6.
Check out my other B7 Audi Videos :
Timing Belt & water pump replacement - • Audi A4 2.0 TDI Timing...
Rear spring replacement - • Audi A4 Avant Rear Sus...
Oil pump drive replacement - • Audi A4 Oil Pump Drive...
How to Retrofit cruise control - • How to Retro fit Cruis...
Oil & filter change - • Audi A4 2.0 TDI Engine...
Washer pipe repair (rear) - • How to fix Audi A4 Est...
NSF Window regulator replacement - • Audi A4 front window r...
Hope the Video helped and If you Could Click Subscribe it will Really help grow my Channel. It's completely free, you'll easily be able to find me in the future and be sure to not miss out on any future content. ru-vid.com?...
Check out my website - www.diydaly.co.uk
DISCLAIMER: Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. This doesn't effect the price you pay!

Авто/Мото

Опубликовано:

17 фев 2021

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 79

@diydaly 3 года назад

Puddle lamp set including wires - ebay.us/VtZeZf S-line projector lamp set - ebay.us/ECeL9s Audi badge projector lamp set - ebay.us/WYamjI If your looking for reasonable price car parts check out these sites: Check Euro car parts - tidd.ly/3lIO7xA (use discount codes on site) Check GSF Car parts - tidd.ly/34pZe7o (use discount codes on site) Check "Car Parts for Less" - tidd.ly/2LNEwIn (use discount codes on site)

@GCS88 10 месяцев назад

Great job something I would do in the future

@diydaly 10 месяцев назад

👍

@rafaloldak5577 3 месяца назад

Thx Mate good job 👍

@diydaly 3 месяца назад

No problem 👍

@kwestmc1679 6 месяцев назад

Hi mate, great video👍👍 I have a question I haven't tried it on the front door yet but I've already tested it on the rear door and it didn't work.... I have the b7 2006 2.0 tdi In the video, when you finish the front door the light comes on immediately, but when you finish the back door it doesn't light up immediately, there is a cut in the video and you can't tell if you do anything to activate it, is there anything that needs to be done ?

@diydaly 6 месяцев назад

No everything should work , it was a long time ago that I did this I’m afraid so I’d have to look back

@adrianthomas2042 2 года назад

Thanks

@user-ho8sc5rt8l 3 года назад

Great bro💚

@diydaly 3 года назад

Thanks mate 👌👍

@user-og9il8bl6w 5 месяцев назад

Hi i have a audi a4 2009 b8 and i have fitted my lights but need to no were to put the wire that clips in to u put urs in number 13 what number will i need to put mine in on the front and back thank you

@hitesh2683 2 месяца назад

Hi, Thanks for the video. I have Audi Q3 (2018), it has the slot for Projection Light, same as showing in your Vidoe, means it will require to cut the plastic part. Could you please help me, if there is Garrage, who can install these.

@diydaly 2 месяца назад

I’m sure some one will do it , but I’m not sure where in your area tbh mate

@johngibraltar Год назад

Hi great video , can you tell me what terminals I should connect to on a 2008 Audi A3

@diydaly Год назад

I’ll try find out

@johngibraltar Год назад

Thanks

@zeRaxx 2 года назад

Could I make the harness myself with the correct gauge of wire? Anything special to it? I would probably put some different connectors on for the lights.

@diydaly 2 года назад

Yeah you could do mate, wouldn't be too bad to do 👍

@michaelshortt4313 2 года назад

I have a 2007 b7 sline, is the pins the same as this video? I’ve bought s-line projectors

@diydaly 2 года назад

Yeah yours will be exactly the same mate 👍

@johndillingham3679 2 года назад

Hi mate. You’ve said “shouldn’t “ need coding. Did the car run ok once you’d finished? John 👍

@diydaly 2 года назад

Yeah all fine mate , I’ve done 4 sets now and none required any coding 👍

@robbooth8184 2 года назад

Hi mate great video. I’ve got an Audi A4 2007. Would this still be the same wiring loom?

@robbooth8184 2 года назад

It’s saying on eBay that this doesn’t fit my car? It’s an 2007 Audi A4 avant.

@diydaly 2 года назад

Thanks for the comment 👌👍 . Is yours a b7 or b8 model, 2007 is right on the change , if it’s a b8 yours may be slightly different

@robbooth8184 2 года назад

@@diydaly it’s definitely a B7.

@diydaly 2 года назад

@@robbooth8184 if it’s a b7 it will be the same , I’d say because it’s close to the cross over they probably just list up to 2006 that’s all

@robbooth8184 2 года назад

@@diydaly can you give any tips on soldering?

@lewiscrawford1679 3 года назад

Going to attempt this on my A3. Ordered the wiring, does both red and white lamps connect to the one cable ?

@diydaly 3 года назад

Yeah they both go into the same loom mate 👍

@lewiscrawford1679 3 года назад

@@diydaly Great thank you. First time trying it but your guide is really helpful thank you 👍

@diydaly 3 года назад

thanks for the comment, much appreciated ... im sure you'll suss it out mate 👍

@lewiscrawford1679 3 года назад

@@diydaly I’ll post pictures once completed. Also other videos are good education also for car folk 👍

@diydaly 3 года назад

👌👌👍

@chriswinters6771 Год назад

Does this projector work only when you have opened doors? Or it gives light all the time?

@diydaly Год назад

Only when the doors open mate

@chriswinters6771 Год назад

@@diydaly Thank you very much and thanks for detailed video :D

@diydaly Год назад

@@chriswinters6771 👍👍

@adrianthomas2042 2 года назад

Hi. Could you please help. I've boughy some Audi logo puddle lights to put in my car which doesn't have lights there at the min. Would you be able to help and advice me on where I would be able to find the wiring. Thanks

@diydaly 2 года назад

Hi , is yours not the same as in the video then?

@adrianthomas2042 2 года назад

@@diydaly hi. Yes mine is the Audi Quattro A4 Black edition 2015 not sure what year the one in the video is. And I do apologize as I'm not really up to date with utube and technology

@adrianthomas2042 2 года назад

@@diydaly mine do have the red reflectors in but would have to make a hole for the underneath ones

@diydaly 2 года назад

@@adrianthomas2042 are yours is the later shape then , this is for the B7 model .. I’m afraid I’m not sure of the wiring for the later model mate

@adrianthomas2042 2 года назад

@@diydaly yes m8, it's the B8. No worries thanks anyway

@jayykelly3621 2 года назад

Does this need coding in? I’m planning on doing this on the weekend but have no access to VCDS, great vid btw👍🏻

@diydaly 2 года назад

Hi mate , no shouldn’t need coding, it’s just plug and play 👌👍

@jayykelly3621 2 года назад

@@diydaly thanks👍🏻

@diydaly 2 года назад

@@jayykelly3621 👍

@ibi2227 Год назад

Mannnnn, been messing with this for too long already. Fitted them and they turned on alright. Put everything back together, screwed everything back again and they ain't working anymore. Can't wrap my head around it...

@diydaly Год назад

🙈 haha that’s a paint! Are you sure there’s not a wire broken in the door joint

@ibi2227 Год назад

Yeaaaa, I feel kinda dumb lol. You'd seen me rage quit last night 😂 turns out ( I should've known) that if you'd working on the car doors ( open) they won't turn on unless you shut the door and wait another 5 minutes.... So i did everything twice..

@martinash4131 2 года назад

Is it same for passenger side ? Got driver side working but cannot get passenger side to work?

@diydaly 2 года назад

Yeah should be exactly the same mate

@martinash4131 2 года назад

Hi have done it all the same so I don't get it??? Must be a problem with the loom will have to get a new one I think but thanks for the vid it helped 👍 alot

@diydaly 2 года назад

@@martinash4131 👍 hopefully you get it sorted