Reviewing Cometic's MLX Head Gaskets 

Just a warning and heads up. Cometic makes great gaskets. But make absolute sure nothing is in between the sandwich layers. The little pieces of rivets that hold the gaskets sandwich can get in between the layers and I can tell you it sucks if you miss it. I called a Freind who is a hardcore engine builder and he just chucked and said he has found it quite often over the years and just checks them as standard procedure. I called Cometic and they completely denied it could happen. I was lucky and found mine on a Cummins diesel build when I installed the head in the truck and noticed it rocked only to find the rivet piece with a boroscope before I torqued it. GreAt gaskets as far as holding 60 psi of boost in a Cummins without an oring

It would be nice to see the difference in the fire ring area. Thanks for the review. Probably the gaskets I will use on my next build.

Was going to throw MLS in my 2JZ, but in sold on the MLX. Will report back with results soon.

I am going to put your head gasket on my 4P piston built boosted Honda b series and not run over 19psi. If it fails I will go on blast. This video sold me. Let's hope it's all truth. God bless.

I've got a set of these MLX gaskets in my 12 to 1 blown 540 and so far so good!

going to get a set for my 428 next time i have the heads off

Hello from Oamaru Sth island New Zealand. Do you advise to dress head gasket with Hylomar spray on prior to installation?. I'm replacing a gasket on my 2012 Nissan Navara D40 St-X Diesel common rail turbo engine

What if the rivet tabs interfere with bolt ons? My Cherokee Ac bracket lands right on the tab.

Can you run these with a copper shim?

I am going to be using your gasket on my build. Do I need to spray the gasket with any sealant?

"Selling Cometic MLX Gaskets"

Really sucks cometic wont answer the phones or return emails

Man this sounds like a hostage video. Hope u got paid well!