ATS Swap · Cummins to Allison Conversion Kit - Installation 

I know there’s some negative stuff out there about ATS, but I’ve worked with these guys with my truck over the last couple years and they’ve been awesome. I have their 5000 Compound Kit and their Allison Conversion on my 2018 Ram 2500. I can’t speak about other products, but thus far their customer service, support, and products have been top notch.

Kudos to your technician who did a terrific presentation here and was very thorough and clear.

I received a quote from ATS for this for my '19 2500. I am seriously considering it but would love to take one for a spin first! Keep in mind that a strong 68RFE build is gonna cost $8k+ and you still will white knuckle it every time you bash the go pedal. The cost of this suddenly becomes reasonable.

Can't wait to do this. Thank you all for your hard work.

Nice clean swap great job squared away

And amazing presentation !

Edgar is awesome 👏🏼 he’s ready to have his own RU-vid channel 😊

Awesome!

Awesome

I'd definitely get my rig transferred over to ats ,if they were in Northern bc

I want one for my 96. Was think about a G56 but if I can put one of these in it's a no brainer! Need my truck for a prototype??? I will even help!

Got a HD transfer case for the ram

Maravilha muito bom tamo junto tudo de bão

Will this be the same on a right hand drive vehicle

How do coast to rebuild a 68RFE with bigger gears

When everybody said putting a tuner on a truck is illegal in here this dude is both of them to the body I sure wish I could afford your complete system what kind of badassness would it be to have a 600 horsepower Cummins in a 1988 Chevrolet Suburban

I wish they were up north in canada 😊

2010 3500 single cab dually - what kit would I need and how much?

any issues running this setup with something like a smarty tuner since both will communicate with the CAN bus?

On Facebook groups all I’ve seen is complaints about these conversions and lack of tech support. Has this been fixed?

Do u make a conversion for a 2016 6.7 auto to a Alison's manual

Do you guys do this swap for a 48re

Enjoy the videos on the conversion but I’m leaving this one early knowing that there’s not a snowballs chance in 😈 that I can afford it.

Can you install Alison auto Trans on 1997 Ford F-350 with 7.3 Diesel engine. I have manual drivetrain now.

What's wrong with 2004 2500 two wheel when transmission engaged the5.9 wants to run away

Have a truck we can test drive with this kit installed? Is the 12,700 to 13,700 installed?

What about driveshaft length?

Do you have a kit for a 207.5 6.7?

How much for a 2013 3500 dullay

Question how much cost 2012 ram 3500.

What about a g56 to Allison swap? I'm Tired of changing gears and dealing with dual disk clutches hopping and jerking with a load hooked to the truck.

It might have been easier to get the engine and trans out of a wrecked school bus or a Freightliner MDT chassis. Add your mods to the engine and boom your done.

What’s the price tag 🏷 on this conversation kit?

is there an Allison conversion for a 2005 Dodge ram 2500 5.9 cummins 4x4?

Got transmissions for 4500 & 5500 ram late model

can you run a tuner with this conversion?

Is there an Allison kit for a 2000 dodge ram 3500 diesel 4x4?

How much hp is it rated for?

It would be nice but they can't get any A50 TCMs because theirs won't work with out it. They are not the only ones being held hostage by GM.🤬. Not until maybe the later part of the 1st 1/4. What happens if you system has a problem. Wait half a yr to get it up and going again? Would of love this system but now rethinking.

I would think for $12K you could rebuild your 68RFE for less and make it strong enough where you don't have to worry about it anymore.

How much is the kit?

What about a 03 3500 nv5600 to Allison

We I can afford it it’ll be CA Yellow.

Just Buy a Dodge Ram, with a AISIN TRANSMISSION. It's Cheaper. Plus the cruise control works Plus the Exhaust Brake Works Plus the AISIN is stronger 💪 than the Allison. Plus any Dodge Ram service Department can work on your truck. Plus Factory Parts are available.

Help please con

Why don’t you guys make a kit to put a proper Eaton Fuller 10 speed in these trucks? This seems insane to spend all this money and and up with a bloody automatic transmission? Also some kits to put a manual in newer 6.7 Ford trucks would be sweet as one can’t even get a brand new one anymore with a manual transmission! Who is spending $90 grand on a new truck with a automatic? I sure as hell won’t I walked away when I couldn’t get a manual on a new one and the damn 6.7 Cummins was derated with a manual transmission! We need some kits to swap in Eaton Fuller Roadrangers into these Dodge Ford and GM pickups I’ve seen conversions done so they will fit.

Bought a rebuilt transmission from these guys I had to send it back 2 times Took 2 months to get it back Tried calling them always a answer machine Never again !

Real trucks don't shift themselves and manuals always outlast hydraulic transmissions by double or more.

I've had bad experience with this company. I never recommend them ! Bought 48re stage 1 and it was horrible build trans fluid was leaking from everywhere end up replacing 2 time they never pay for labor.

ATS is the worst place to by a transmission in less than two years I had to bring it back 7 time's and I'm having more problems in less than 32000 miles!!!!!!!

Asin is a much better transmission than the Allison.