98 civic Y7 to Y8 intake mani swap 

Great video ! This is so underrated. After watching 5 videos on how to do it , this is the one I learned the most , thanks !

Thanks for the video. It helped me out when I swap my y7 intake for a y8 automatic from 98 that I had laying around. I noticed the difference in power and sound its louder now. Have y8 head that I'm gonna rebuild and then it going on there too.

This is the most clear video I've seen in how this swap is done! Thanks

This video is PERFECT. just did my auto to manual trans swap and I swapped the intake while the motor was out thinking I could just kinda slap it on lol

Great video man. I'm going to have to rewatch this when I do this

Thanks buddy you video saves me a lot searching time! God bless you

Good work mate, im about to swap d14 manifold to d16 and your video helped me a lot. My shitbox is eating more oil than fuel so i know i should do other things in it but being a civic owner have its rules right XD. keep up the good work greets from poland.

thank you so much this helped me with the swap so much

Perfect step by step bro help me 110%.....

The manifold with the extra holes by the ports is a 99-00. The Auto-Trans version has the ports on the back blocked off, which is what you want. So the best manifold to use is a '96 to '98 Auto-Trans EX one.

Good job

If i put a brand new or rebuilt head on a 1998 civic dx (d16y7)with 250,000 miles, without rebuilding the bottom end, is that a bad idea? Is there any chance of blowing engine? Any opinions would be appreciated.

Dope

That one bracket i can't loosen up removed the head, distributor, all the hoses and fuel rail

i did this swap and it idles around 1500-2000 rpm and jumps around 100+/-rpm Theres a vaccum leak somewhere. i dont know if i cleared the old gasket enough but i tried for hours and u can still see some barely but im not sure if thats okay. also while scraping off old gasket i accidently cut the head/surface around studs and now theres little holes and cuts on it. would that cause vaccum leak?

bringing it back, is this the sameway for the z6 intake on the y7?

HVAC sensor. lol Only poking a little fun thanks for sharing

Nice 👍🏽 ... i have a 2000 d16y7 and just recently got a y8 vtech head . Any thought on anything else i should do ?

Did you get an special gasket ? It looks thinker? I have the orginal gasket and isnt thick enough for conversion.

Couple questions. What year is your car if it’s a 99-00 what ecu you running and is the IACv a 2 or 3 wire. It would help me fix my car thanks

Would this be the same process on a 1999 civic?

Did u have to grind the welds down

Questions sir is it fine to run a d15b7 manifold on a d16y7 engine??

👍👍👍👍

Have a problem where I turn my car on my rpm’s instantly surge to 3000

Are you using your y7 throttle body?

Good morning mate! How did you install the canister sensor on the Y8 collector? hugs

Do you have a y7 or y8 head?

I never understand why people feel the need to put music on the videos. I’m forever turning volume up and down

thank you so much this helped me with the swap so much